Cover V04, I04
Article
Figure 1
Figure 2
Listing 1
Listing 2
Listing 3
Listing 4
Listing 5

jul95.tar


Figure 1: /usr/lib/uucp/Dialers

#ident    "@(#)Dialers   2.4 - 91/06/21"
#
#
# hayesslow:   for 'normal' calls limited to 300 baud
# hayes12:     for 'normal' calls limited to 1200 baud
# hayes:  for 'normal' calls limited to 2400 baud
# hayes96:     for 'normal' calls to high-speed modems
# hayesNO:     for non-error correcting calls to high-speed modems
#
hayes12   =,-,  "" \M\dATS37=5Q0W2X4&Q6\r\c OK\r ATDT\T\r\c CONNECT
\m\c
hayes          =,-,  "" \M\dATS37=6Q0W2X4&Q6\r\c OK\r ATDT\T\r\c
CONNECT \m\c
hayes96        =,-,  "" \M\dATQ0S46=136W2X4\r\c OK\r ATDT\T\r\c ""
\d\c\d\c\d\c\d\c\d\c CONNECT \m\c
hayesNO        =,-,  "" \M\dATQ0S46=136W2X4&Q6\r\c OK\r ATDT\T\r\c
"" \d\c\d\c\d\c\d\c\d\c CONNECT \m\c
hayesslow =,-,  "" \M\dATQ0X4&Q6S37=3\r\c OK\r ATDT\T\r\c ""
\d\c\d\c\d\c CONNECT \m\c
#
#  Hayes Pager Entry
#
#  The line of expect/send sequences are very similar to above
#  entries except: modem code S7=10 for number of seconds to wait
#  for carrier signal from answering modem. 10 seconds since we
#  aren't calling a modem.  The only other changes are at the end
#  when we are expecting CARRIER or more exactly NO CARRIER as the
#  result from the dial, if it states BUSY then we try again.
#  After we get NO CARRIER message send a BREAK command and exit
#  the cu process which will get the rest of its commands from the
#  numpager script.
#
hayespag  =,-,  "" \M\dATQ0S7=10S46=136W2X4\r\c OK\r ATDT\T\r\c ""
\d\c\d\c\d\c\d\c CARRIER \K
#
#